Dash Lynx Dash Camera Power Supply Plug-and-Play for 2016-2023 Toyota Tacoma
(as of Jan 23,2023 04:22:02 UTC – Details)
The Dash Lynx Toyota Plug-n-play Dash Camera wiring kit (Patent-Pending) allows you to effortlessly install a dash camera, Radar, navigation, GPS, and/or smart phones safely and quickly into your vehicle. With two USB Type A sockets, you can chose to run your cables on the left side, right side, or both, for a cleaner and easier install. The Dash Lynx will provide power to your dash camera or accessories only when the vehicle’s ignition is on, or when the engine is running. When the vehicle is off, it turns off. The Dash Lynx power supply has 2 USB 5 watt outputs. Quick access USB Type-A sockets allow you to easily change from micro-USB to mini-USB for all major Dash Camera brands. Designed by aerospace engineers in America with the highest safety standards, the Dash Lynx comes with 3 embedded auto-resetting electric fuses and reverse polarity protection to protect your devices in the event of a bad jump start or electrical shock. The fuses are properly designed and specified for each vehicle year/make/model so that in the event of a dash camera failure or short, your vehicles main power harness is not affected. Dash Lynx will not void your vehicles warranty. Every vehicle we design a Dash Lynx for has a full power budget analysis to make sure the vehicle has the proper size fusing and available power to supply to the Dash Lynx. Dash Lynx uses authentic Texas Instruments voltage regulator chips and American sourced Capacitors and components. Don’t be fooled by counterfeit chips that die after months of use. Designed with low EMI/electrical noise components, soft start, and peak current-mode control – Dash Lynx power supply accepts inputs as low as 3.5 volts to 28 volts and outputs a steady 5 volts for your USB devices. Circuit board independently designed and tested to withstand operational temperatures over 80°C with two dash cameras running, cold temperatures as low as -40°C, non-operational temperatures over 100°C. Developed and designed in Florida the durable Plastic enclosure will not soften in the Sun’s radiant heat. The plastic enclosure is rated to over 300°F and attached with genuine 3M high-temp hook & loop fasteners to ensure your Dash Lynx stays mounted to the mirror (or windshield) even in the hottest states. Note: Dash Lynx can power a total output of 10 watts. This can power 2 dash cameras*, or 1 dash camera and 1 smart phone, however cannot power 2 smart phones at the same time (one port will be automatically shut off in this mode). (*Dash camera power consumptions independently tested by Dash Lynx using the top selling brand Dash Cameras, most cameras are under 0.5 Amps rms at 5 volts, because Dash Lynx is a step down power supply, the total power consumption will be less than the output current would be at 5 volts. For example at 14.5 volts vehicle alternator power the power output will be <0.2 Amps load on your vehicle, creating a safe power draw designed for your vehicle). Vehicle Compatibility: 2018-2023 Toyota Tundra*, 2016-2023 Toyota Tacoma*, 2016-2020 Toyota Sienna*, 2011-2022 Toyota Highlander*, *with 12 pin auto-dimming Rear View Mirror.